 |
| The bag. |
 |
 |
| Lifting a fabricated
girder. The
chains
are by Sword Models. |
|
Lifting beams are used to reduce forces
being applied to loads as a result of non-vertical chains
and straps.
This accessory is a beam modelled on a beam configuration
with a capacity of 40 tons. The review set is in
red (RAL 3002).
Packaging
This model comes in a small bag with the beam wrapped in
tissue. There are no chains included and there are
no instructions.
Detail
and Features
The part is metal and painted well in a slightly matt finish.
There are no graphics applied.
The beam can be lifted either on the central lug, or by
chains on the outer lugs. The central lug is large
and will not fit the opening on all crane hooks.
Chains can be hung from any of six positions on each end
of the beam allowing lifting widths of 4 to 9cm. .
Quality
and Price
It is a well made metal item with a good finish, but is relatively
expensive.
Overall
This is a heavy looking lifting beam which poses well.
It is highly recommended if the cost is acceptable.
Footnotes
This accessory was first shown at the Nuremberg Toy
Fair in 2011 and was also made in yellow (RAL 1007).
|
|
|
